Page 1 of 1

Pre Engage High Torque Starter

Posted: Thu Feb 26, 2015 4:31 pm
by bobwhittaker
When at Race Retro purchased a PowerLite starter motor from Eurolec Components to suit the " A " Series . It has always been reluctant to crank when stone cold even with a " Rebuilt " starter motor and all connections made good . Twenty minutes to fit still using the bulkhead solenoid . Result , instant almost silent start up , no " thrashing and mashing " of the bendix , into mesh turn the engine and it ran .
Not particularly cheap but it " Sounds " a better job . Well suited ! ! !
BOB WHITTAKER

Re: Pre Engage High Torque Starter

Posted: Fri Feb 27, 2015 11:40 am
by Splat
Yup! Particularly effective with engines in a higher state of tune and it all sounds so much less harmful.